Tesla Model Y Battery Health Reports & Testing Guide

Model years
2022 – 2023
Vehicle type
Electric Vehicle (EV)

Where is the Tesla Model Y OBD port?

Tesla Model Y OBD-II diagnostic port location
Tesla Model Y (2022 – 2023) diagnostic port

How to test Tesla Model Y battery health

  1. Open the front passenger door and remove the rubber trim along the passenger footwell from the seat up to the glove compartment area
  2. Use the metal trim tool to remove the circular plastic tab
  3. Pry back the trim until you can see the diagnostic connector deep in the passenger footwell (typically light blue)
  4. Use the BLUE Tesla cable (from your testing kit) and plug in the diagnostic connector on one side, the vsNEW device on the other side, and the USB-C cable into the center console USB-C connector
  5. Enter the front seat, press the brake, and make sure your vehicle is in DRIVE MODE
  6. Start the vsNEW app and select your Tesla model
  7. The vsNEW app will automatically connect to the device, read the VIN, collect the BMS data, and issue a vsNEW battery health report
Watch: testing a Tesla Model Y with the vsNEW device

Tesla Model Y testing quirks

The vehicle will likely go into a sleep mode during the test, unless you press the brake and keep the vehicle in DRIVE mode. We recommend pressing the brake every 30 seconds to keep the BMS awake and sending data to the vsNEW device.

Common Tesla Model Y battery issues to look for

One of the most common HV battery failure modes is caused by cell imbalance issues, where either a single cell or a group of cells are not able to hold as much charge as the rest of the cells in the battery pack. This can develop as a result of -

1) stress to the battery from excessive supercharging or extremely low temperature charging

2) natural aging

3) manufacturing defects

In these cases, if additional energy goes into a cell that cannot hold additional charge, that energy is released as heat. In extreme cases, that excess heat can lead to thermal runaway and a catastrophic battery fire.

The good news is that BMSs are constantly monitoring for cell imbalances to prevent overcharging cells. However, if a BMS detects an imbalance issue, it will throw one of several codes on the screen - BMS_u018, BMS_u029, BMS_a079, or BMS_a074, and will restrict the maximum charge level of the battery to a maximum of 50% SOC or even as low as 30% SOC. The vehicle is still drivable in this state - and is safe to operate - but you will have a fraction of your original range. Often, Tesla's solution is a complete battery replacement, even if the root cause is a single cell.

vsNEW checks for early signs of cell imbalance issues, acting like an early warning system. For best results, we work with EV service shops that can conduct a full battery test under load, along with a visual inspection to give you a complete analysis.

Example Tesla Model Y battery health report

View the full example report

Other Tesla Model Y model years

← All supported vehicles